cesta
    cesta  
cesta

 
 

How to install    



First and foremost we must prepare the area where we will place the vinyl: should be clean and dry, free of dust or grease. Remind that the surface must be completely smooth. If you just paint the wall, we recommend placing the vinyl after 2 weeks for the wall to absorb paint well.
Remove the vinyl from its packaging and place preferably on a table. Unroll it on a flat surface and rub the design with a dry cloth to have more grip and remain completely flat.
las tres capas del material
Paso 1
Place the design on the wall, holding it lengthwise across the top with masking tape of low adherence. Thus, we see through the translucent paper  placement the correct position and imagine the final finish. If the vinyl is made of several motifs, we recommend placing the larger or main draw first and then place the rest, overlapping each other at least 2 mm. in the area of intersection to improve adherence and prevent irregularities.
Paso 2
Remove the backing paper slowly from the top, letting the transfer adhere to the wall while you go with it with a spatula.
Paso 3
Once you have removed the backing paper,you must review the vinyl pressing with a spatula or with a cloth to facilitate adherence.
Paso 4
Remove the masking tape.
Paso 5
Remove the transfer from the wall slowly pulling down parallel to the wall, taking special care that the edges of the vinyl are well adhered. If at the moment of withdrawing it the amount of spare transfer is too large,you may cut it to facilitate the placement task. This usually occurs mainly in large figures.

Paso 6
The vinyl is in place, now just have to enjoy it.

 

 MUST BEAR IN MIND

THE PLACEMENT OF THE VINYL MUST BE MADE WITHIN ONE MONTH AS MAXIMUM FROM WHICH IT RECEIVES IT.

Depending on the final size, the designs of our decorative vinyl can be delivered divided into several parts, in order to facilitate its installation. 

If during installation air bubbles are formed, they could be eliminated by pricking them with a pin and rubbing with a cloth from the edge toward the perforated area to remove all air.

For the placement of a vinyl in metallic or glass surfaces, we recommend spraying area with water first to prevent bubbles and facilitate removal of the transfer. Never use this method on a wall. 

 

* The vinils do not have return because of the fact that they are created specially for each client by his/her  own requested combination.

Our vinyls have no guaranty because we do not make responsible about the
decision of our costumer about where they are going to install our product.
We only recommend our products for indoor, over completely smooth surfaces, far
from heaters sources and humidity

 

illustración
 
01. Home
separador
 
08. FAQ
 
 
Visa - MasterCard - PayPal